ORMEC SAC-SW225/EB | 225W amplifier | 2.25A continuous output

Key Technical Specifications Product model: SAC-SW225/EB Manufacturer: ORMEC Motor type: AC brushless permanent magnet servo motor Rated output power: 225 W Continuous output current: 2.25 A Peak output current: 4.5 A AC input: 120 / 240 VAC single-phase, 50/60 Hz Control modes: Position, velocity, torque Feedback: Incremental encoder Operating temperature: -10 °C to +60 °C,…

GE VMIVME-7750 | VMEbus single board computer for industrial VME racks

Key Technical Specifications Parameter Value Product Model VMIVME-7750-734001 (350-027750-734001 K) Manufacturer GE Intelligent Platforms Form Factor 6U VMEbus, single board computer CPU PowerPC 750, 350 MHz Memory 128 MB SDRAM soldered; 32 MB onboard flash VMEbus Interface VME64, A16/A24/A32 addressing, master/slave Network Ports Dual 10/100 Mbps Ethernet Serial Ports 2 × RS232 Expansion PMC site…

SWITCHING TR-500Q-P-F1 3503311-02 | 85–264 VAC wide input power module

Key Technical Specifications Product Model: TR-500Q-P-F1 (3503311-02) Manufacturer: SWITCHING Application System: Industrial control racks, DCS, PLC and automation I/O systems Rated Power: 500 W AC Input: 85–264 VAC, 47–63 Hz DC Output: Regulated 24 VDC Protection Features: Overvoltage, overcurrent, short-circuit, over-temperature lockout Efficiency: Up to 94% at nominal load Operating Temperature: -20 °C to +70…

GE VMIVME-7750 VMIVME-7750-746001 | VMEbus single-board computer

Key Technical Specifications Product model: VMIVME-7750-746001 (350-027750-746001 P) Manufacturer: GE Bus standard: VMEbus IEEE 1014 Processor: 1 GHz embedded CPU Memory: Onboard RAM, soldered flash memory for boot firmware Network: Dual 10/100BASE-T Ethernet ports Front panel I/O: Serial port, USB, reset switch, status LEDs VME operation: Acts as VMEbus master and slave Supply: +5 VDC…

GE SR489-P1-HI-A20-E-H | Multilin Generator Management Protection Relay

Key Technical Specifications Product Model: SR489-P1-HI-A20-E-H Manufacturer: GE Multilin Power Supply: 70–265 VAC / 90–300 VDC CT Input: 5 A nominal; VT input for generator terminal voltage Frequency Range: 48 Hz to 62 Hz Protection Elements: Stator differential, reverse power, loss of excitation, negative sequence, over/under frequency, 100% stator ground Communication: RS232 front port, rear…

ORMEC SAC-SW220/EB | ServoWire brushless servo drive for motion control

Key Technical Specifications Parameter Value Product Model SAC-SW220/EB Manufacturer ORMEC Systems Drive Type Digital brushless AC servo amplifier, ServoWire bus Input Power 230 VAC single-phase, 50/60 Hz Continuous Output Power 220 W Continuous Motor Current 3 A RMS Control Modes Torque, velocity, position Feedback Digital incremental encoder Motion Bus ServoWire serial link for multi-axis coordination…

GE 531X302DCIAWG1 | Mark VIeS DC instrumentation rack card

Key Technical Specifications Product model: 531X302DCIAWG1 Manufacturer: GE System compatibility: Mark VIeS turbine control rack Input channels: 8 differential DC analog inputs Supported signal types: 4–20 mA, 0–20 mA, 0–10 V DC Full-scale accuracy: ±0.1% for 4–20 mA, ±0.15% for 0–10 V DC Power requirement: 24 V DC, 20–30 V DC operating range, max 300…

BENTLY 3500/22M 138607-01 | Transient Data Interface rack gateway module

Key Technical Specifications Product Model: 3500/22M (138607-01) Manufacturer: Bently Nevada Application System: 3500 rotating machinery vibration and protection rack Mandatory Slot: Slot 1, adjacent to rack power supply Power Source: 24 VDC backplane, max power draw 10.2 W Front Ports: USB‑B local configuration, 10/100BASE-TX RJ45 Ethernet Transient Sampling Rate: Up to 64 kHz per active…